From: Callum Hughes (Callum.Hughes@sis.securicor.co.uk)
Date: Tue Jun 25 2002 - 09:18:38 EDT
Hi everyone
Could someone tell me how you completely reset a T3 disk array to the
factory install config? We've received a temporary array from a loan company
that we think already has an IP address and configuration installed. Hence,
when we attach it to our server, we can't telnet into it. (We've editied
/etc/ethers, /etc/hosts, we're running rarpd and have even added the device
to the arp table).
This is a really urgent request so any help would be GREATLY appreciated!
Kindest regards,
Callum A. Hughes SCSA
Unix Systems Engineer
e: callum.hughes@sis.securicor.co.uk
**********************************************************************
The information contained in this e-mail message is intended
only for the individuals named above. If you are not the
intended recipient, you should be aware that any
dissemination, distribution, forwarding or other duplication
of this communication is strictly prohibited. The views
expressed in this e-mail are those of the individual author
and not necessarily those of
Securicor Information Systems Limited.
Prior to taking any action based upon this e-mail message
you should seek appropriate confirmation of its authenticity.
If you have received this e-mail in error, please immediately
notify the sender by using the e-mail reply facility.
**********************************************************************
_____________________________________________________________________
This message has been checked for all known viruses on behalf of Securicor Information Systems by the MessageLabs. For further information visit http://www.messagelabs.com or Email: mailsweeper.info@sis.securicor.co.uk
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:24:30 EDT