From: Markus Mayer (mymaillists@gmx.at)
Date: Fri May 20 2005 - 08:46:50 EDT
Hi Managers,
First off - thanks for the great list! I've often been able to solve problems
by looking through the archives.
I'm having problems getting to a soft partition I created on a raid 1 disk.
After I've created the soft partition, I can't mount it or do an mkfs on it.
I've been following the information in the Solaris Volume Manager
Administration Guide January 2005 however there is no information on how I
can actually start using a soft partition after I've set it up. I would
greatly appreciate a few pointers on what I should do after the steps below
that I've done.
regards
Markus
bash-3.00# metainit d100 -p d50 1g
d100: Soft Partition is setup
bash-3.00# metastat d100
d100: Soft Partition
Device: d50
State: Okay
Size: 2097152 blocks (1.0 GB)
Extent Start Block Block count
0 32 2097152
d50: Mirror
Submirror 0: d51
State: Okay
Submirror 1: d52
State: Okay
Pass: 1
Read option: roundrobin (default)
Write option: parallel (default)
Size: 10241280 blocks (4.9 GB)
d51: Submirror of d50
State: Okay
Size: 10241280 blocks (4.9 GB)
Stripe 0:
Device Start Block Dbase State Reloc Hot Spare
c1d0s5 0 No Okay Yes
d52: Submirror of d50
State: Okay
Size: 10241280 blocks (4.9 GB)
Stripe 0:
Device Start Block Dbase State Reloc Hot Spare
c1d1s5 0 No Okay Yes
Device Relocation Information:
Device Reloc Device ID
c1d0 Yes id1,cmdk@ASAMSUNG_SP0802N=0637J5FWA06325
c1d1 Yes id1,cmdk@ASAMSUNG_SP0802N=0637J5FWA06693
bash-3.00# mkfs d100
mkfs: Operation not applicable for FSType nfs
bash-3.00# mkfs -F UFS d100
mkfs: FSType UFS not installed in the kernel
bash-3.00# mkfs -F ufs d100
size not specified
ufs usage: mkfs [-F FSType] [-V] [-m] [-o options] special size(sectors) \
[nsect ntrack bsize fragsize cpg free rps nbpi opt apc gap nrpos maxcontig
mtb]
-m : dump fs cmd line used to make this partition
-V :print this command line and return
-o :ufs options: :nsect=32,ntrack=16,bsize=8192,fragsize=1024
-o :ufs options: :cgsize=0,free=0,rps=60,nbpi=2048,opt=t
-o :ufs options: :apc=0,gap=0,nrpos=0,maxcontig=0
-o :ufs options: :mtb=n
NOTE that all -o suboptions: must be separated only by commas so as to
be parsed as a single argument
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:30:44 EDT