From: egold@fsa.com
Date: Fri Apr 22 2005 - 16:48:15 EDT
Hi Gurus,
Im running solaris 8 02/04.
I have an emulex 9002-E hba and trying to connect to a sun 6320 SAN.
I have connected to this san in the past but instead I was using qlogic
HBA's.
When I used the qlogic hbas, i would run these commands to connect to the
sun 6320 san:
luxadm -e port
luxadm qlgc
cfgadm -al
cfgadm -c configure c2
edit /kernel/drv/scsi_vhci.conf to enable mpxio
These dont seem to work with the emulex 9002-E hba.
Can you please tell me how to get this setup working?
I need step by step instructions on how to install the drivers, get the
WWN's and configure mpxio for this HBA.
thanks alot!
____________________________________
This e-mail message is for the sole use of the intended recipient(s) and
may contain proprietary, confidential and/or privileged information. Any
unauthorized review, use, disclosure or distribution is prohibited. If you
are not the intended recipient (or an employee or agent responsible to
deliver it to the intended recipient), you may not copy or deliver this
message to anyone. In such case, you should destroy this message and kindly
notify the sender by reply e-mail.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:30:35 EDT