From: Andreas Höschler (ahoesch@smartsoft.de)
Date: Wed Jan 12 2005 - 05:02:17 EST
Dear managers,
I am trying to setup HylaFax on a Netra X1 with Solaris 9. I
successfully built HylaFax from source. During the configuration
/usr/local/sbin/faxsetup
I am asked for the serial port the modem is connected to. My Elsa
MicroLink 28.8TQV is connected to the second serial port using the
25Pin Sub-D that came with the Netra and a straight-through patch
cable. I therefore typed "ttyb" and got
Probing for best speed to talk to modem: 38400 19200 9600 4800 2400 1200
Unable to deduce DTE-DCE speed; check that you are using the
correct device and/or that your modem is setup properly. If
all else fails, try the -s option to lock the speed.
No LEDs of the modem were blinking during this test. What serial port
should I use for this? Do I have to type ttyb or /dev/ttyb? Any chance
the LomA port willwork better. Any further configuration steps
necessary?
I also tried my luck with
tip /dev/cua/b
connected
an hope I would see anything when typing ATZ or the like but I get no
response. The session is blocked. Not even Ctrl-C helps.
What am I missing here? Thanks a lot!
Regards,
Andreas
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:59 EDT