[UPDATE] Possible solaris 8 use dynamic ip address ?

From: SangIn Park (sipark_m@fineit.net)
Date: Mon Jan 10 2005 - 01:15:32 EST


Hi, Gurus

I'm action follow :

touch /etc/hostname.le0
touch /etc/dhcp.le0

Cable is direct from cable modem. and cable connect properly SPARC BOX. But, I getting follow boot messages :

SPARCstation 20 MP (2 X SuperSPARC-II), No Keyboard
ROM Rev. 2.25, 384 MB memory installed, Serial #8020724.
Ethernet address 8:0:20:7a:62:f4, Host ID: 727a62f4.

Rebooting with command:
Boot device: /iommu/sbus/espdma@f,400000/esp@f,800000/sd@1,0:a File and args:
SunOS Release 5.9 Version Generic_117171-07 32-bit
Copyright 1983-2003 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
configuring IPv4 interfaces: le0 qfe0.
starting DHCP on primary interface le0
le0: No carrier - cable disconnected or hub link test disabled?
ifconfig: le0: wait timed out, operation still pending...
starting DHCP on interface qfe0
/sbin/dhcpinfo: interface not in appropriate state for command
Hostname: psi
The system is coming up. Please wait.
starting rpc services: rpcbind done.
Setting default IPv4 interface for multicast: add net 224.0/4: gateway psi
syslog service starting.
Jan 6 20:05:31 psi sendmail[222]: My unqualified host name (localhost) unknown; sleeping for retry
Jan 6 20:05:31 psi sendmail[223]: My unqualified host name (localhost) unknown; sleeping for retry
volume management starting.
The system is ready.

psi console login:

# ifconfig -a
lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1
        inet 127.0.0.1 netmask ff000000
le0: flags=1004842<BROADCAST,RUNNING,MULTICAST,DHCP,IPv4> mtu 1500 index 2
        inet 0.0.0.0 netmask 0
        ether 8:0:20:7a:62:f4

----- Original Message -----
From: "PSI" <sipark_m@fineit.net>
To: "Sun Managers" <sunmanagers@sunmanagers.org>
Sent: Tuesday, January 04, 2005 11:30 PM
Subject: Possible solaris 8 use dynamic ip address ?

> Hi, Gurus
>
> I will use dynamic(fluid, not fixed) ip address for internet on cable internet(like adsl or vdsl).
> I try to set a le0 and qfe0~4 using DHCP. These are using command that ipconfig, unsysconfig.
> But IP address not set.
>
> How to setting a dynamic IP address ? I using Internet(using cable) through ISP.
>
> Do you have any idea?
>
>
> Thanks & Regards,
> Sang-In, Park
> _______________________________________________
> sunmanagers mailing list
> sunmanagers@sunmanagers.org
> http://www.sunmanagers.org/mailman/listinfo/sunmanagers
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers



This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:58 EDT