From: Johnny Koen (Johnny.Koen@Investec.co.za)
Date: Mon Oct 18 2004 - 09:38:48 EDT
Hi
We bought two 3510's, one with dual raid controller snd the other just a
jbod. I have connected them up and started playing with. I see that when
you create a logical drive you can only choose raid 5, 1 and zero. But
no raid 1+0.
Now do I have to stripe one unit "hardware stipe" and then use software
mirror to mirror the one unit to the other one? Please give me some
advice on how to setup the 3510 to use hardware stripe and mirror.
Many thanks
Cheers
Johnny
IMPORTANT NOTICE:
If you are not the intended recipient of this email (or such person's
authorised representative), then :
(a) please notify the sender of this email immediately by return email,
facsimile or telephone and delete this message from your system;
(b) you may not print, store, forward or copy this message or any part thereof
or disclose or cause information in this message to be
disclosed to any other person.
The information in or attached to this email message is confidential and may
be subject to legal privilege and client confidentiality.
In addition this message is subject to important restrictions, qualifications
and disclaimers ("the disclaimer") that must be accessed and
read by copying the following address into your Internet browser's address bar
: http://www.investec.com/emaildisclaimer/
The disclaimer also provides our corporate information and names of our
directors as required by law.
The disclaimer is deemed to form part of this message in terms of Section 11
of the Electronic Communications and Transactions Act 25 of 2002.
If you cannot access the disclaimer, please obtain a copy thereof from us by
sending an email to : disclaimer@investec.co.za
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:35 EDT