From: Ray Pengelly (ray@biomed.queensu.ca)
Date: Thu Sep 09 2004 - 21:37:36 EDT
Hello,
I have Solstice Backup 6.1 running on a Solaris 9 x86 machine. This is
attached to an L25 jukebox via an adaptec u320 SCSI controller. I installed
some driver patches for the scsi cards (I have onboard u320 and a 29160 PCI
card) in my machine and it changed the controller numbers so my paths have
changed. Everything else seemed to handle the change except for the Legato
Driver (/dev/lus). It used to point to controller 3 which is now become the
IDE controller. How can I go about mapping it to the right SCSI controller
and target (controller 2 target 3 instead of c2t3). The tape drive seems
fine as I can get status from "mt -t /dev/rmt/0cbn status". When I run
/etc/LGTOuscsi/inquire I get the robot at scsidev@2.2.0. When I run jbconfig
it craps out with a 'read_elem_unload_failure' which means it can't move the
robot.
Can I uninstall the legato driver and reinstall using pkgrm and pkgadd. I
know they are in SUNWsbus2? Or can I just change /dev/lus to point to the
correct device?
Anyone ever dealt with /dev/lus before?
TIA,
Ray
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:25 EDT