From: amit.gpt@wipro.com
Date: Thu Aug 12 2004 - 00:00:14 EDT
Hello All,
We know HPUX clustering with MC/ServiceGuard. Using the same we had
configured
the xclock command to be running in the failover mode.
We want to configure the same XClock command to run in failover mode in Sun
Cluster.
we want "/usr/openwin/bin/xclock -display <client-address>:0.0" command to
run
in cluster environment.
Currently we have configured the two node cluster, without any registered
resource groups . The scstat -v command gives us node online.
Any inputs on this would be appreciated...
Regards
Amit
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin@wipro.com immediately
and destroy all copies of this message and any attachments.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin@wipro.com immediately
and destroy all copies of this message and any attachments.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:16 EDT