From: Adam Mazza (adam@68e.com)
Date: Mon Jun 21 2004 - 13:08:06 EDT
Hello,
I have a v240 running Solaris 9 04/04 directly attatched to FC0 of a
3510FC. The problem is the OS does not seem to be recognizing the array.
The configuration is as follows:
1) Qlogic qla2340-CK card. I installed the most recent driver and dmesg
shows the following upon bootup:
QLogic qla2300 Fibre Channel Driver v4.13 Instance: 0 Firmware v3.2
then brings the loop up, shows the adapter node-name, port-name, and
adapter-port-id then the SCSI-target-id with fibre-channel-node-name. Then
is shows the 2 luns I have enabled off the array:
kern.info] qla2300-hba0-SCSI-target-id-40-lun-0-enable;
kern.info] qla2300-hba0-SCSI-target-id-40-lun-1-enable;
and finally:
kern.info] PCI-device: fibre-channel@1, qla23000
kern.info] qla23000 is /pci@1d,700000/fibre-channel@1
So the card seems to recognize the array correctly.
2) 3510FC array. I've upgraded the FW, SES, and PLD on this:
sho inquiry
Vendor: SUN
Product: StorEdge 3510
Revision: 327R
NVRAM Defaults: 327R 3510 v2.63
Bootrecord Version: 1.31H
Serial Number: 07D30F
sho ses
Ch Id Chassis Vendor/Product ID Rev PLD WWNN WWPN
-------------------------------------------------------------------------------
2 12 07D30F SUN StorEdge 3510F A 1040 1000 204000C0FF07D30F
214000C0FF07D30F
Topology: loop(a)
3 12 07D30F SUN StorEdge 3510F D 1040 1000 204000C0FF07D30F
224000C0FF07D30F
Topology: loop(b)
and the array is in loop only mode.
3) SFS - I downloaded SAN_4.4a_install_it from Sun along with the
3510array.sh script and they both ran fine.
Unfortunately luxadm probe, or the sccli command does not see the array
(except via oob management).
I was wondering if anyone else is using this particular FC card with this
array. I've been told it should work, but since it's not a Sun branded
card it's not listed on Sun's site as supported.
Thanks
Adam Mazza
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:28:55 EDT