From: Bhavesh Shah (bshah@citadon.com)
Date: Fri May 28 2004 - 15:49:22 EDT
Hi,
Thanks to all who replied especially
Tony Walsh
Anjan Dave
Pascal
>From whom I got the hint what to check for. Finally I figured it out.
The problem was Active termination Jumper on the Diff controller card
(SYMBIOS LOGIC - SYM 22802) was on (enabled). Disabled (Off) it and it
started working.
Thanks a lot and sorry if I missed anyone.
Bhavesh
My Original Question was:
--------------------------
Hi Gurus,
I have Sun Fire 280R Box where I have connected A1000 with PCI Diff SCSI
Controller in slot PCI2 and am getting following error messages while
booting:
And sits there forever.
WARNING: /pci@8,700000/scsi@3,1 (glm3):
Connected command timeout for Target 3.0
WARNING: /pci@8,700000/scsi@3,1 (glm3):
Target 3 reducing sync. transfer rate
WARNING: /pci@8,700000/scsi@3,1 (glm3):
got SCSI bus reset
WARNING: /pci@8,700000/scsi@3,1 (glm3):
Connected command timeout for Target 3.0
WARNING: /pci@8,700000/scsi@3,1 (glm3):
got SCSI bus reset
The same A1000 I connect to E 3500 works fine where we have S-BUS Diff
SCSI controller.
The PCI Diff SCSI controller is new.
Any Help will be greatly appreciated.
Thanks
B
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:28:45 EDT