From: GoijI P (goijiud@hotmail.com)
Date: Wed Apr 21 2004 - 18:27:04 EDT
got an utra10 with solaris2.8.
seems like SUN display monitor is bad with "no input signal"
message. (Green indocator turns to yellow on two ultra10's).
how do i know if m64config or fbconfig is used to configure
the graphic card?.
how to re-enable built-in display port with a new NIC or Sony
monitor?. just take the graphic card out , reboot it and plug in
the SONY monitor into buil-in monitor port?.
_________________________________________________________________
>From must-see cities to the best beaches, plan a getaway with the Spring
Travel Guide! http://special.msn.com/local/springtravel.armx
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:28:30 EDT