using both eth0 ports with the same IP

From: Samael_pan (samael_pan@yahoo.com)
Date: Mon Dec 22 2003 - 16:59:02 EST

• Next message: Bruce Purcell: ""unknown" host"
• Previous message: sunsa_tx@yahoo.com: "ifconfig: plumb: qfe0: Bad file number"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Sun Gurus!
 
I have 10 SunFire V100, and two loadBalancers. I need each machine to be connected to a load balancer, both load balancers are completely identical... this is a requirement, one primary and one secondary. I need to have both ethernet ports dmfe0 and dmfe1 have the same IP. The idea is that if one of the LB goes flaky, we will power down the primary and power up the secondary and the machines will switch from port 1 (primary) to port 2 9secondary) but the apps which are IP dependant won't care.
 
Is there a way to do this?
 
-Samael
Yahoo! Photos - Get your photo on the big screen in Times Square
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers

• Next message: Bruce Purcell: ""unknown" host"
• Previous message: sunsa_tx@yahoo.com: "ifconfig: plumb: qfe0: Bad file number"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:27:43 EDT