From: Shane Kelly (AT/EEI) (shane.kelly@ericsson.com)
Date: Thu Nov 20 2003 - 09:17:59 EST
Hi,
I have an L9 tape drive. Latest firmware 023B, connected using differential SCSI card to an Ultra 10 running Sol 9, with recommended patch cluster.
I am having problems getting it to run at max density. The max I can get is around 40Gb, sometimes 45Gb but this is just an estimate. I am using DLT IV tapes.
I have tried using /dev/rmt/0ubn and /dev/rmt/0cbn, both are same (supposed to be!)
I have put the correct lines in st.conf and taken them out, no difference.
I cannot see a way to change the compression ratio on the drive other than using /dev/rmt/0[c][u][l][h] identifiers.
What am I missing? I should be able to get ~80 Gb from these tapes, shouldn't I?
Many thanks,
Regards,
Shane
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:27:31 EDT