From: Jordi Vidal (jordivi@wtransnet.net)
Date: Thu Oct 16 2003 - 12:12:14 EDT
Thanks for the quick answer to:
Rob De Langhe
Hargrave, Mark E
Davis, Uly
Ximo Domenech
The way to check link speed (10/100) and Duplex mode (Full/half)
is to get it from "ndd /dev/ce" parameters link_mode and link_speed.
ndd -set instance 0 (for ce0/hme0/whatever0)
Duplex Mode:
ndd -get /dev/ce link_mode
0 -> half
1 -> full
Link Speed:
ndd -get /dev/ce link_speed
0 -> 10 Mbps
1 -> 100 Mbps
I also get a response about use "netstat -k", but I thing the above is
easier.
Regards,
Jordi
-----Original Message-----
From: Jordi Vidal [mailto:jordivi@wtransnet.net]
Sent: Thursday, October 16, 2003 5:28 PM
To: sunmanagers@sunmanagers.org
Subject: How to check fdx/hdx network status
Hi
How can I know if my network card is working at 100Mbps fdx or
100Mbps hdx?.
I have no fisical access, so I cannot plug/unplug the UTP and tail
-f dmesg output.
"ndd /dev/ce" reports "1" for all capabilities
Regards
Jordi
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
>>>
30th Telindus International Symposium
Thursday, October 30, 2003 - Brussels Expo, Belgium
Check out the complete conference programme, exhibition,
workshops and register now for this high value 'must attend' event!
http://www.telindussymposium.com
<<<
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:27:18 EDT