From: Kevin Davidson (kdavidson@transaction-one.com)
Date: Wed Jun 04 2003 - 09:46:36 EDT
Gurus,
I have created a new LUN on an A1000 array. However, when I try to access the
array via either the RAID Manager 6 GUI or the command line tools, I get the
message "Unable to Scan Module".
I have worked through all the steps in the Recover Guru - rebooted the host,
run the "clean" application, etc, but am still getting the same result.
Sun support have suggeested that there is a problem with the controller and I
will have to rebuild the entire array.
Any other suggestions?
Will summarize.
Thanks,
Kevin
-- Kevin Davidson | UNIX Systems Administrator Transaction One | www.transaction-one.com 020 8358 9126 | kdavidson@transaction-one.com _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:26:31 EDT