From: Simon Kuhn (sak8@eecs.cwru.edu)
Date: Wed May 21 2003 - 15:44:22 EDT
Hello,
I'm trying to install a Sun StorEdge L9 autoloader on Solaris 9 04/03, and I'm
totally stuck.
I have an Ultra 1 with a SBus differential SCSI card connected to the L9, and
am able to see both the tape drive and robotics with probe-scsi-all. According
to /kernel/drv/st.conf, I no longer have to configure it specifically for the
L9 (it's a DLT8000 drive). After doing a reconfigure boot, the tape drive
shows up as /dev/rmt/0. If I use the tape drive's LCD interface to move a tape
into the drive, I can read/write to it successfully.
However, the robotics interface does not show up anywhere in /devices or
dmesg. We've tried changing SCSI IDs (there are no other devices on this card)
to no avail. The terminator is the original one that shipped with the L9.
I haven't been able to find any documentation on this drive that doesn't just
say "install it on your operating system" (from either HP or Sun). Can anyone
help?
Thanks,
-- Simon Kuhn UNIX Admin _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:26:27 EDT