HoneyD-Win32 Parse Error --- ROADBLOCK

From: wrenm@prosum.com
Date: Wed Jun 22 2005 - 18:12:33 EDT

('binary' encoding is not supported, stored as-is) Hi Roger –

First of all thank you for writing your book. After weeks of research I finally ran across it and it put all of the pieces together for me. Well, almost all of the pieces.

I have installed HoneyD-Win32 as described in your book and if I simply run the command “honeyd –d” it pops up and says it is listening. I can even see it catch traffic! Woo hoo!

The problem is when I try to feed it a config file. Even the most simplest of configurations give me a PARSE error. For example:

 

Create Windows 98
Annotate “Windows 98”
Set Windows 98 Personality “Windows 98”
BIND 1.1.1.1 Windows 98

I even double checked to make sure that “Windows 98” was defined in my nmap.prints file.

Any idea where I can go from here? I feel like I’m steps away from the holy grail but the final inches are stretching into miles.

Regards,

Wren

Sr. Consultant
Prosum Technology Group

This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:54:28 EDT