From: Aaron Drew (ripper@internode.on.net)
Date: Mon May 24 2004 - 17:49:01 EDT
Airsnort can be temperamental. Kismet will actually make logs that airsnort
can then process offline. I had to use "iwpriv wlan0 mode monitor 1" to get
mine to work right. (PRISM2 hostap drivers)
On Mon, 24 May 2004 07:07 am, securityfocus@arkam.it wrote:
> ok, I've tried the auditor bootable cd, it works great on my vaio laptop. I
> shut down the centrino wireless card, and inserted my cisco aironet 350.
> During the boot, the cd recognizes the cisco card as "airo_cs", and I can
> run kismet without a problem.
> I've also tried airsnort, but I cannot manage to make it work. If I simply
> select eth0 and other as driver, and press start, it returns me an error
> about the monitor mode unset. So I open a shell and run "iwconfig eth0 mode
> monitor", and retry. Airsnort does not give any error, but it cannot see my
> home wlan (40bit wep), while kismet sees it. Also, monitor mode command in
> the shell goes on running until I hit ctrl+C, and in the same time airsnort
> gives me the error about monitor mode.
> What's the problem? Is airsnort able to use a cisco card? Is the "other"
> driver correct?
> Thanks in advance,
> Luca Dell'Oca.
-- - Aaron "Today's mighty oak is just yesterday's nut that held its ground."
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:53:55 EDT