The NEXTSTEP/OpenStep FAQ

! to the table of contents
< to the previous section:
> to the next section:


5.45 How to use two internal hard drives

drives, two internal

It is possible to fit a second internal hard drive in a NeXT slab, in addition to the floppy drive and the first hard drive. The second drive must be third height, or 1 inch high. There is no room for a half height device. Buy a bracket or make one out

of sheet metal for the 1 inch high drive. On 25 MHz mono stations the SIMMs are smaller and the drive doesn't have to go all the way against the back wall. In this case, glue the bracket to the underside of the NextStation cover, centered from side t

o side and as far to the back as possible. This is sufficient. On 25 MHz colorstations, however, one must file away a bit of the interior metal on the cover in order to glue the bracket fully to the rear of the cover. Once this modification is done, th

e drive will clear the RAM when the cover is closed. Screw the drive into the bracket, with the power and SCSI plugs toward the right hand side of the NextStation so that the cables will reach. Go to your favorite computer store and get both a "dual int

ernal SCSI bus cable" and a "dual internal SCSI power cable." Plug in the cables to both internal hard drives and close the cover.

This was verified on both a 25 MHz mono and a 25 MHz color NextStation. No power or heating problems occurred.



This document was converted from LaTeX using Karl Ewald's latex2html.