*************************GSP example**********************
  Type control b. You will see:
  Service Processor login: type return here
  Service Processor password: type return here
  Welcome to HP Guardian Service Processor
  Unitialized Model, System Name: Prelude
  GSP> ca
  CA
  This command allows you to modify the local and remote console
  configuration.
  Do you want to modify parameters on the Local Console Port? (Y/[N]) N
  
  Do you want to modify parameters on the Remote Console Port? (Y/[N]) y

  Current Modem Protocol is : CCITT
  Do you want to modify it ? (Y/[N])Y 		<----- change to Bell
  Current Remote Console Port baud rate is : 9600 bits/s
  Do you want to modify it ? (Y/[N]) Y
  Y
  Enter new Remote Console Port baud rate (in bits/s) : 19200
  19200
  New Remote Console Port baud rate will be : 19200 bits/s
  Please confirm (Y/[N]) : y
  y

  -> Remote Console Port baud rate will be updated.

  Current Flow Control is : Software
  Do you want to modify it ? (Y/[N]) N
  Sending Configuration Strings to Modem is : Enabled
  Do you want to modify it ? (Y/[N]) N
  Modem Presence is : always connected
  Do you want to modify it ? (Y/[N]) N
  Command execution may take 25 seconds.

  -> Parameters have been updated.

|============================================|
|          Below portion is for N Class machine                         |
|============================================|
  GSP Host Name: machine name
  GSP>er
  ER
  Current console access state is :
  Remote Console : Disabled
  LAN Console : Enabled
  Do you want to modify this configuration ? (Y/[N]) y
  y
  Do you want to Enable the Remote Console ? (Y/[N]) y
  y

  -> Remote Console will be : Enabled

  Command execution may take 25 seconds.
  New console access state is :
  Remote Console : Enabled
  LAN Console : Enabled
  GSP Host Name: machine
  NOTE: Use the MR command to reset the modem then type 'co' to return to
  console mode.


OR

|============================================|
|          Below portion is for A & L Class machine                   |
|============================================|
GSP Host Name:  uninitialized
GSP> er


ER

Current remote/modem port access: Session 


Do you want to modify this configuration? (Y/[N]) Y
Y
Remote/modem serial port access options:

    [L]ocked-out: Lock out all dial-in access.
    [G]SP       : Dial-in results in a GSP login.
    [S]ession   : O/S controls modem for dial-in and dial-out

GSP may page in any mode if modem is not in use. 
O/S may use modem in Session mode only. 

Please indicate the new mode for the remote/modem console serial port, 
or <CR> to retain current value. Choose one of (L, G, S):G

    New remote/modem port access settings will be: GSP 

   Confirm? (Y/[N]): Y

Command execution may take 25 seconds.

Current remote/modem port access: GSP 


  -> To disable Remote Console Access go into GSP and type 'dr' :

  GSP>dr