From: Bill Verzal (BVerzal@KOMATSUNA.COM)
Date: Tue Mar 16 2004 - 09:32:05 EST
Compression is on by default.
BV
--------------------------------------------------------
"If everything is coming your way, then you are in the wrong lane"
Bill Verzal
AIX Administrator, Komatsu America
(847) 970-3726 - direct
(847) 970-4184 - fax
"Willeat, Todd"
<TWilleat@MHP.SMH
S.COM> To
Sent by: IBM AIX aix-l@Princeton.EDU
Discussion List cc
<aix-l@Princeton.
EDU> Subject
LTO-2 configuration on AIX 5.2
03/15/2004 06:12
PM
Please respond to
IBM AIX
Discussion List
<aix-l@Princeton.
EDU>
Hi all,
I am setting up an ADIC Scalar i2000 library on AIX 5.2. AIX sees the
drives, but recognizes them as Other FC SCSI Tape Drive instead of LTO-2.
It
did recognize them as LTO-2 with the Atape driver, but the driver did not
allow the changer to be seen. So, I am running without Atape. My question
is
how to tell if the LTO-2 drives are set to use compression. I have
configured Legato NetWorker to use /dev/rmt0.1 and can access the drives
and
read tape fine, but both density settings are 0 which means it should use
the drive's default setting. Is compression the default? Here is what smit
shows:
Tape Drive rmt0
Tape Drive type ost
Tape Drive interface fcp
Description Other FC SCSI Tape Dr>
Status Available
Location 1j-08-01
Parent adapter fscsi0
Connection address 1
BLOCK size (0=variable length) [0]
+
Use DEVICE BUFFERS during writes yes
+
RETURN error on tape change or reset no
+
Use EXTENDED file marks yes
+
RESERVE/RELEASE support no
+
BLOCK SIZE for variable length support [0]
+#
DENSITY setting #1 [0]
+#
DENSITY setting #2 [0]
+#
Set delay after a FAILED command [45]
+#
Set timeout for the READ or WRITE command [144]
+#
_______________________________________
/ Todd A. Willeat \
| UNIX / Storage Administrator |
| Mercy Health Plans |
| 425 South Woods Mill Road |
_ | Chesterfield, Missouri 63017-3492 | _
/ )| (314) 214-2329 / (314) 214-8202 (fax) |( \
/ / | twilleat@mhp.mercy.net | \ \
_( (_ | http://www.mercyhealthplans.com/ | _) )_
(((\ \> \/->___________<-=-=-=-=->___________<-\/ </ /)))
(\\\\ \_/ / \ \_/ ////)
\ / \ /
\ _/ \_ /
/ / \ \
/___/ \___\
This e-mail contains information which (a) may be PROPRIETARY IN NATURE OR
OTHERWISE PROTECTED BY LAW FROM DISCLOSURE, and (b) is intended only for
the
use of the addressee (s) named above. If you are not the addressee, or the
person responsible for delivering this to the addressee (s), you are hereby
notified that reading, copying or distributing this e-mail is prohibited.
If
you have received this e-mail in error, please contact the sender
immediately.
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:42 EDT