From: Ayman Rayyan (ayman.rayyan@STS.COM.JO)
Date: Wed Feb 25 2004 - 08:44:16 EST
Thnanx so much.
Best Regards
_________________________________________________
Ayman Rayyan
IBM pSeries & AIX System Engineer
STS Group , Amman-Jordan
Tel : +962 6 5802626
Cell : +962 79 6925356
Fax : +962 6 5829213
Ayman.Rayyan@sts.com.jo
www.sts.com.jo
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU] On Behalf Of
jeff barratt-mccartney
Sent: Wednesday, February 25, 2004 3:26 PM
To: aix-l@Princeton.EDU
Subject: Re: Emulex LP 9002
yes. PCI-X is backwards compatible with PCI
btw. I believe if you put the LP9002L card in a 32bit slot, it will
negotiate at 1GB/sec also: remember that any PCI-X bus you put a card
into will operate down to the lowest common denominator, so if you put a
33Mhz card in a PCI-X slot, all cards on that bus will run at 33Mhz
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU]On Behalf Of
Ayman Rayyan
Sent: Wednesday, February 25, 2004 7:18 AM
To: aix-l@Princeton.EDU
Subject: FW: Emulex LP 9002
Dear all:
I had found the compatible HBA card which is Emulex LP9002L & its
supported by AIX 5.1, my notice is that this is a PCI 32 or 64 bit card
while 650 & 630 are PCI-X, so does PCI-X slots supporting PCI cards ?
-----Original Message-----
From: Ayman Rayyan
Sent: Wednesday, February 25, 2004 12:48 PM
To: aix-l
Subject: Emulex LP 9002
Dear All:
An any Pls. help to find the compatible emulex HBA to connect 650 & 630
to symmetrix 8730 EMC storage ?
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:37 EDT