From: John Jolet (john.jolet@FXFN.COM)
Date: Tue Dec 30 2003 - 10:55:37 EST
my guess then, is that you need, in some way, to get power to those drives...assuming they aren't already spinning up.
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU]On Behalf Of Maguire, James
Sent: Tuesday, December 30, 2003 9:44 AM
To: aix-l@Princeton.EDU
Subject: Re: New disks in 7026
Yes they are scsi. They are mounted in a 2104-DU3 expandable storage unit. (I'm just reading the specs here, I'm never dealt with this unit before)
Thanks,
Jim
-----Original Message-----
From: John Jolet [mailto:john.jolet@FXFN.COM]
Sent: Tuesday, December 30, 2003 10:23 AM
To: aix-l@Princeton.EDU
Subject: Re: New disks in 7026
i'm not familiar with that drive module...are these scsi disks?
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU]On Behalf Of Maguire, James
Sent: Tuesday, December 30, 2003 8:56 AM
To: aix-l@Princeton.EDU
Subject: Re: New disks in 7026
John,
I have never dealt with this machine before, (only worked with F50's), but these go into a 2104 drive module. They don't show up at all. There were 8 disks in it already, and these are the 9th and 10th.
Thanks
Jim
-----Original Message-----
From: John Jolet [mailto:john.jolet@FXFN.COM]
Sent: Tuesday, December 30, 2003 9:42 AM
To: aix-l@Princeton.EDU
Subject: Re: New disks in 7026
You don't say whether they were hotpluggable disks or not, so we'll assume they were. after you inserted the drives, did you get power back to the drive slots? You might check and see if they show up, but as defined, not available.
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU]On Behalf Of Maguire, James
Sent: Tuesday, December 30, 2003 7:38 AM
To: aix-l@Princeton.EDU
Subject: New disks in 7026
Hello list. I just received two 73gb drives for a 7026-B80. I put them in place yesterday, and thought they would become available by running cfgmgr, but they do not appear. So, I scheduled a reboot last night hoping that would take care of it, but still no luck. In looking at the Installation instructions it appears that it might need a power off/ power on. Is there any way around that?
Thanks,
Jim
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:26 EDT