From: Bill Thompson (bill.thompson@GOODYEAR.COM)
Date: Tue Nov 26 2002 - 13:35:18 EST
shekar,
The best way is with "spmon".
Here's an example (note that node 14 is powerd down)
-> spmon -G -d
1. Checking server process
Process 34600 has accumulated 41 minutes and 17 seconds.
Check ok
2. Opening connection to server
Connection opened
Check ok
3. Querying frame(s)
2 frame(s)
Check ok
4. Checking frames
Controller Slot 17 Switch Switch Power supplies
Frame Responds Switch Power Clocking A B C D
----------------------------------------------------------------
1 yes yes on 0 on on on N/A
2 yes yes on 3 on on on on
5. Checking nodes
--------------------------------- Frame 1
-------------------------------------
Frame Node Node Host/Switch Key Env Front Panel
LCD/LED is
Slot Number Type Power Responds Switch Fail LCD/LED
Flashing
-------------------------------------------------------------------------------
1 1 wide on yes yes normal no LEDs are blank no
3 3 wide on yes yes normal no LEDs are blank no
5 5 thin on yes yes normal no LEDs are blank no
6 6 thin on yes yes normal no LEDs are blank no
7 7 wide on yes yes normal no LEDs are blank no
9 9 wide on yes yes normal no LEDs are blank no
11 11 wide on yes yes normal no LEDs are blank no
13 13 thin on yes yes normal no LEDs are blank no
14 14 thin off no autojn normal no LEDs are blank no
--------------------------------- Frame 2
-------------------------------------
Frame Node Node Host/Switch Key Env Front Panel
LCD/LED is
Slot Number Type Power Responds Switch Fail LCD/LED
Flashing
-------------------------------------------------------------------------------
1 17 high on yes yes normal no LCDs are blank no
5 21 high on yes yes normal no LCDs are blank no
Bill Thompson
Sr UNIX Systems Administrator
The Goodyear Tire & Rubber Co.
Contains Confidential and/or Proprietary Information
May Not Be Copied or Disseminated Without Express Consent of The Goodyear
Tire & Rubber Company.
AIX-L Archives: http://marc.theaimsgroup.com/?l=aix-l&r=1&w=2
----- Original Message -----
From: "CHANDRASHEKAR, MANI" <MANI_CHANDRASHEKAR@FLEET.COM>
Newsgroups: bit.listserv.aix-l
To: <aix-l@Princeton.EDU>
Sent: Tuesday, November 26, 2002 1:16 PM
Subject: spnode check
> All,
>
> Is there any command or way to check from the SP control
> workstation if the SP node is alive..?, other than the ping command.
>
> Thanks..
>
> shekar......
>
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:16:23 EDT