From: Adityanarayana K (SYSTEMS-ISL-ITPL) (adityanarayanak@VYSBANK.COM)
Date: Sat Nov 23 2002 - 05:20:20 EST
Yes, Both the Major numbers are same.
-----Original Message-----
From: cbaker@GOODYEAR.COM [mailto:cbaker@GOODYEAR.COM]
Sent: Saturday, November 23, 2002 1:44 AM
To: aix-l@Princeton.EDU
Subject: Re: URGENT ATTENTION PLEASE!!!!! PROBLEM WHILE STARTING CLUSTER
(attachments removed)
Do you still have the same Major Number on both nodes for the shared VG?
Christopher M. Baker
Senior Technical Support Analyst
DSE/TCO
Goodyear Tire and Rubber Company
=================================================
Contains Confidential and/or Proprietary Information.
May not be copied or disseminated without the expressed
written consent of The Goodyear Tire & Rubber Company.
=================================================
"Praveen Kumar K
(TSE-IFT-ITPL)" To: aix-l@Princeton.EDU
<praveenkumark@VY cc:
SBANK.COM> Subject: URGENT ATTENTION
PLEASE!!!!! PROBLEM WHILE STARTING CLUSTER
Sent by: IBM AIX
Discussion List
<aix-l@Princeton.
EDU>
11/22/2002 03:02
PM
Please respond to
IBM AIX
Discussion List
Hi eneryone,
In a setup where we have 2 s80's running on a
cluster(HACMP),when we start the cluster on primary it goes through but
when
we start cluster on secondary it doesn't go through..When we have done a
cluster verification on primary we haven't found any errors except for
warnings which are as follows...
shared vg vg_data hot found on the secondary...
shared vg vg_bckp not found on secondary..
The same setup was running fine before,but this problem has creeped up
only,
when we recently had an upgrade of our systems to ML10
For information:-
when the same shared vg's were varied off on primary and varied on
secondary
we were through with out any problem..(Manually)
If someone can throw some light on this it would be helpful very much....
Warm regards
TIA
Praveen Kumar.K
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:16:22 EDT