From: Vesna Vranesic (vesna.vranesic@RZB.AT)
Date: Mon Sep 30 2002 - 10:30:07 EDT
I had once very similar problem. After one migration of all the SSA HDs
from one to another
drawer I couldn't see all loops in both directions (diag -> ...-> SSA Link
Verification).
Trying to upgrade all micro codes for enclosure, SSA adapters and HDs
brought another
frustration: the upgrade of microcode for enclosure didn't want to finish.
Everything got
fine after IBM replaced the enclosure.
Ciao
Vesna
SGreen@KRAFTEUROPE.COM@Princeton.EDU am 30.09.2002 16:07:39
Bitte antworten an aix-l@princeton.edu@inet
Gesendet von: aix-l@Princeton.EDU
An: aix-l@Princeton.EDU
Kopie:
Thema: Re: SSA disks fail to configure after clone
On my list of things to check, (see the end of my original post).
By the way: the adapter in the Silver nodes is a 6215, not a 6225.
Simon Green
Philip Morris ITSC Europe
AIX-L Archive at http://marc.theaimsgroup.com/?l=aix-l&r=1&w=2
AIX FAQ at http://www.faqs.org/faqs/aix-faq/
N.B. Unsolicited email from vendors will seldom be appreciated.
> -----Original Message-----
> From: Baker, Sanchia [mailto:Sanchia.B.Baker@ACCENTURE.COM]
> Sent: 30 September 2002 14:53
> To: aix-l@Princeton.EDU
> Subject: Re: SSA disks fail to configure after clone
>
>
> mmm how about the firmware level on the ssa ?
>
> Sanchia
>
> -----Original Message-----
> From: Green, Simon [mailto:SGreen@KRAFTEUROPE.COM]
> Sent: 30 September 2002 14:41
> To: aix-l@Princeton.EDU
> Subject: SSA disks fail to configure after clone
>
>
> Short version:
> I cloned a system (different hardware). Moved the SSA cables
> across but the
> LEDs on the adapter stayed black.
> Moved the cables back to the original server and they were
> still black!
> Later, for no obvious reason they went green and everything
> was OK. Why?
>
>
> Long version:
<SNIP>
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:16:14 EDT