From: cbaker@GOODYEAR.COM
Date: Mon Apr 19 2004 - 17:34:37 EDT
Where do you do the "xhost +" at? Can't open an xterm on the HMC and fire that off. Can't do it in the ascii/text login
(CTRL-ALT-F1) since you don't have a DISPLAY there.
I just tried creating an "/etc/X0.hosts" file with a "+" or a specific remote system name. Then I rebooted the HMC, but that did not
take either.
(Of course I am on a old HMC version/release 3.1.2, so that may be an issue?)
Thanks,
Christopher M. Baker
Senior Technical Support Analyst
DSE/TCO
Goodyear Tire and Rubber Company
=================================================
Contains Confidential and/or Proprietary Information.
May not be copied or disseminated without the expressed
written consent of The Goodyear Tire & Rubber Company.
=================================================
Bill Verzal
<BVerzal@KOMATSU To: aix-l@Princeton.EDU
NA.COM> cc: (bcc: Chris Baker/NA/GDYR)
Sent by: IBM AIX Subject: Re: Xwindows on an HMC
Discussion List
<aix-l@Princeton
.EDU>
04/19/04 12:25
PM
Please respond
to IBM AIX
Discussion List
As long as you are not going across the serial - yes.
Just set the display to <HMC IP ADDRESS:0.0> and run the XTERM on the LPAR.
You might have to 'xhost', but I've done it.
BV
--------------------------------------------------------
"If everything is coming your way, then you are in the wrong lane"
Bill Verzal
AIX Administrator, Komatsu America
(847) 970-3726 - direct
(847) 970-4184 - fax
Inshan Singh
<isingh@CO.PALM-B
EACH.FL.US> To
Sent by: IBM AIX aix-l@Princeton.EDU
Discussion List cc
<aix-l@Princeton.
EDU> Subject
Xwindows on an HMC
04/19/2004 10:59
AM
Please respond to
IBM AIX
Discussion List
<aix-l@Princeton.
EDU>
Is it possible to bring up X windows from an Lpar on an HMC?
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:50 EDT